Other Hardware

Hex Head Security Bits

We take an S2 material T30 Torx bit as an example. The hardness is HRC 58-62. The minimum break torque is ≥30 N·m. This follows ISO 1173. In real use, you can safely put out 20-25 N·m of torque. This

Hex L-shaped Wrench

We take an H5 size (5 mm across flats) S2 material L wrench as an example. The hardness is HRC 58-62. The minimum break torque is ≥25 N·m. This follows ISO 2936. In real use, you can safely put out

Spring Tension Pins

We take a φ6 mm (outer diameter) spring pin as an example. The initial spring force (pin fully out) is 5-10 N. The final compression force (pin fully pressed into the body) is 15-25 N. The pin

Heavy Duty Lifting Eye Bolts

The working load limit (WLL): M8 vertical lift ≤0.2 tons. M10 ≤0.3 tons. M12 ≤0.5 tons. M16 ≤1.0 tons. M20 ≤1.5 tons. The design safety factor is 4:1 or 5:1. The ultimate break load is 4-5 times the

Quality Hose Clamps

We take a φ20-32 mm (fit range) stainless steel hose clamp as an example. You tighten to the recommended torque (about 3-5 N·m). The radial clamp force on the hose is 200-400 N. This ensures no leaks